The Novitec Ferrari F12 Berlinetta With 700+ HP and three or more Piece Wheels

In 2012, Ferrari unveiled the new F12 Berlinetta super car or truck to replace its getting older Ferrari 599 GTB Fiorano grand touring super car or truck. Exactly the same entrance-mid engined, rear-wheel drive layout was carried over and improved upon with model new technological innovation, a a lot more refined chassis, and also far better effectiveness, wrapped within a redesigned shell. Using the new super auto staying so new for the market place, there have not been any upgrade products or modifications obtainable for entrepreneurs until finally Novitec Rosso launched its new performance offer with motor tuning, chassis upgrades, three or more piece wheels, and interior refinements.

Compared to its successor, the Ferrari F12 Berlinetta capabilities a larger, additional highly effective six.3-liter, naturally-aspirated V-12 motor that produces 640 horsepower. The staff at Novitec Rosso considered which the factory output just wasn’t ample and produced a whole new set of upgrades that significantly increased energy. As an alternative to creating an all-out engine upgrade software that modified the within of the engine, the German tuning business targeted primarily on bolt-on upgrades to ship far more energy towards the rear three or more piece wheels. The six.3-liter motor was fitted with a fresh sport air intake program, a new exhaust with steering wheel-adjustable butterfly valves, and an ECU tune that optimizes the ignition, timing, fuel injection, and pushes rear the motor redline to 8,900 RPM.

The result in the engine upgrades is an astonishing 763 horsepower (545 kW) at 8,500 RPM and 518 lb-ft. (703 Nm) at half-dozen,300 RPM. This enables the Italian super car to accelerate to 62 mph in less than seconds and achieve a high speed of in excess of 345 km/h (214 mph), creating it each the fastest and most powerful Ferrari for the industry.

In order to reliably have the option to put all of that power towards the floor with out continuously dropping traction, the Novitec Rosso workforce needed to upgrade the chassis and add three or more piece wheels. For greater dealing with and an optimum center of gravity, a collection of sport springs ended up installed that reduce the trip height by 40 mm with the entrance and rear axles. A new hydraulic lift system was also installed to raise the entrance axle by 40 mm to overcome speed bumps and parking ramps, and automatically lowers at 80 km/h. A whole new collection of a few piece wheels were fitted in the 9.5J x 21 front and 12J x 22 rear staggered setup and equipped with 255/30 ZR 21 and 335/25 ZR 22 Pirelli large-efficiency tires to enhance total grip and dealing with qualities.

Novitec Rosso also will allow for buyers to add inside options in leather, alcantara, and carbon fiber for any custom appear. The exterior can be fitted with black tail your lights and side markers which are the only other visual modification in addition to the three piece wheels.